The software plots the oziexplorer height grid in 3D and then overlays the map image on the grid (this is elevation called texturing) to produce a 3D map.
Elevation Display at elevation Startup - If ticked the Elevation Display window data (shows the Elevation under the mouse position) will be shown when OziExplorer is elevation started.
When the term OziExplorer3D is used data the 3D map viewer is being referred to, when the term OziExplorer is used the OziExplorer GPS Mapping Software is being referred.
If ticked the height profile of the map will be smooth the map will take oziexplorer longer to create.Important, If unticked OziExplorer will not make use of Elevation from Elevation Files or allow 3D maps to be created.The image section is saved compressed in the 3D1 file.The paths below are then set to point data to where the files are located.This happens if the uncompressed size of the image is less than.5 MBytes.OziExplorer 3, d - Elevation Configuration, system Tab, use Elevation Data.See the, height Data help for more details of the type of data supported.If ticked OziExplorer will interpolate the elevation between the known height points (the height grid in the height data file) using a best fit spline through a 16 point grid.Zoom in and out. These are tutorial the categories of DEM files that OziExplorer codes supports.
DEM File Paths Tab, elevation Data Type and path, as OziExplorer is started (or exiting OziExplorer Elevation Configuration) then.
Most maps which can be viewed in OziExplorer can be viewed in 3D (some image types are excluded for licensing reasons).
Elevation Adjust -The figure entered here (in meters) is added to the elevation data elevation of the map as the map is created.
Main OziExplorer3D Features: Display maps.
View waypoints, tracks and points on the 3D map.
Number Vertices - This shows the maximum number of vertices that you will allow.
Save, copy to the clipboard and print the current 3D map view.This allows the height data used to create the 3D map to be adjusted to allow for difference in height datums etc.The checkbox beside each path enables the file cheat type to be made serial active (used in OziExplorer) or not active (not used in OziExplorer).Sub folders belonging to these paths are also scanned for files.This value is set to a labview conservative 25,000 as a default but can be set between 0 and 2,000,000 as you become familiar with your system performance.OziExplorer3D is software which allows map images to be viewed in 3D with the ability to rotate songs in all directions and zoom in and out of the view.Compression Option - Compressed tar visual file Transfer Option - FTP.Save Small Image Section in 3D File - If ticked the required part of the map image is saved in the 3D1 file.